- 积分
- 294
- 在线时间
- 599 小时
- 最后登录
- 2024-5-3
- 阅读权限
- 50
- 精华
- 0
- UID
- 804232
- 帖子
- 276
- 精华
- 0
- 经验
- 294 点
- 金钱
- 255 ¥
- 注册时间
- 2015-11-18
|
本帖最后由 laomao9000 于 2022-3-21 15:34 编辑
耳朵收货?这是最大的误导!
要有数据!如果有apx555的测试可以证明你的说法,自然不用争辩。
看下DAPHILE作者的说明
Q10. How should I configure the audio settings in order to maximize
the audio quality?
A10. In short: Use bit-perfect playback and have good enough
DAC. Longer version: My own view and experience is that if you
have good enough DAC (using asynchronous data transfer from PC,
independently powered, galvanic isolation between USB receiver
and actual DAC+analog circuitry, etc...) any audio device
parameters don't effect on sound quality as long as you use bit
perfect playback and keep the parameters sensible so that they
don't cause any buffer under-runs (and have also some tolerance
for high system load situations). If the DAC does not meet those
requirements the chances that computer HW+SW combination effect
on sound quality are much higher and the effects may be caused by
many unpredictable reasons (HW, SW, parameters, specific
combinations of them, etc...). You just have to experiment and
try to find the best setup (or buy better DAC ;-).
翻一下:
问题10。我应该如何配置音频设置以获取最好的音频质量?
回答10:
简而言之:使用bit-perfect 播放,并有足够好的DAC解码器。
更长的版本:我个人的观点和经验是,如果有足够好的DAC(使用异步数据传输/独立供电/适当电气隔离的USB接口界面+DAC+模拟电路等。),任何音频设备只要使用 bit-perfect ,参数不会影响音质完美的播放,并保持参数合理,以便不要造成任何缓冲区不足(并且要有一定的宽容度)。如果DAC不满足这些要求,要求计算机硬件+软件组合效果的可能性对音质的影响要高得多,其影响可能是由许多不可预测的原因(硬件、软件、参数、特定它们的组合等等)。你只需要做实验尝试找到最好的设置(或购买更好的DAC;-)。 |
|